ALUMINUM LIFTER INSTALLATION

  • ONEWHEEL XR

  • ONEWHEEL PLUS

ALUMINUM LIFTER GALLERY

STEP 1: Turn the Onewheel upside down and remove the two screws (4 total) at the furthest point of the front and back. These screws mount the bumper to the front and back foot pad.

STEP 2: If a spacer was provided (based on board type), align the spacer to the Lifter and check to ensure the screw holes are aligned.

STEP 3: Insert two mounting bolts into the holes from the Titanium side through the spacer and tighten the bolts by hand.

STEP 4: Finish tightening the bolts with Allen wrench.

STEP 5: Install Lifter Pad where the foot would hit against the lifters using the three small M4 bolts with Phillips screwdrivers.

STEP 6: Apply grip tape horizontally to the vertical wall of the inside of the unit between your footpad and the Lifter Pad.